Shanghai Exheat Industries Co., Ltd
+86-13545529361

milkheatexchangerdistributor

Nov 30, 2021

There are two types of milking systems in general: barrel and pipeline milking systems. The barrel milking system directly collects the cows in a vacuum portable barrel. Portable barrels are usually ground-mounted and suspended. Generally in modern dairy farms, the milking system used is a pipeline milking system. Usually the pipeline milking system uses rigid heat-resistant glass or stainless steel non-toxic pipes, and the vacuum pressure is transmitted from the milk collector to each milking system. Group of cups and deliver milk from each milking cup to the milk collector. The pipeline milking machine can be used for tethered or tethered cattle houses, and can also be used for milking in the milking parlor.


Therefore, how to clean the milking equipment correctly and effectively is also a very critical part of the daily production of dairy farms. The correct and effective cleaning of the milking equipment is the first step to ensure product quality, and at the same time prevent cross-infection of some diseases in animals.


The general cleaning procedure is: (may vary depending on the brand and model of the equipment used in the dairy farm)


Pre-rinsing


Rinse the equipment with warm water at 35~40°C immediately after use until it is clear


Washing water cannot be reused


Cycle cleaning


Cycle cleaning for 5-10 minutes


The amount of cleaning agent is determined by the engineer of the supplier's after-sales service department according to the local water quality


Keep the water temperature at 80~85°C


The water temperature shall not be lower than 40°C when discharged after cyclic cleaning

Use the safety pump to pump the cleaning agent quantitatively, and it is strictly forbidden to mix the safety pumps


In order to ensure the effect of the cleaning agent and avoid accidents, please do not directly use the bucket to add the cleaning agent to the tank


When cleaning manually, choose appropriate clear tools according to the equipment and pipeline. Do not use wire brushes or rough cleaning pads,


Because this will damage the surface of the device.


After cleaning


Rinse with clean cold water, the time is about 5 minutes


Sewage


After flushing, drain the system completely through the lowest point of the equipment


maintenance


Regularly maintain, test and calibrate milking equipment (including vacuum pumps, stabilizers, pulsators, etc.)


Regularly replace the rubber accessories such as the inner sleeve of the milk cup to ensure that the milking equipment maintains a good operating condition!